Checking oil level
WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
- Call up Service functions (Drive) in BMW diagnosis system
- Carry out oil level check in accordance with instructions
IMPORTANT:
On the twin-clutch gearbox a run-in check fluid change is not
required at 2000 km.
Use only the approved gear oil for dual clutch transmission GS7D36SG .
Failure to comply with this instruction will result in serious damage to the twin-clutch gearbox.
IMPORTANT:
The testing and filling procedure must
be completed before the transmission oil temperature of 40°C is reached.
If a temperature in excess of 40°C is reached and no oil has emerged, insert the fluid adjusting screw and repeat the testing and filling procedure when it has cooled down.
Installation note:
Tighten down filler plug using
- Hexagon wrench 8 A/F
- Torque wrench
- Socket 8 A/F