12 31 Alternator with Drive and Mounting Parts
WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATION - ALTERNATOR WITH DRIVE AND MOUNTING PARTS
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Wires to alternator | ||||
| Terminal D+ | M10/M20 | 5 Nm | ||
| All/others | M6 | 7 Nm | ||
| Terminal B+ | S38/B38 | 8 Nm | ||
| All/others | M8 | 13 Nm | ||
| 2AZ Pulley | All | 45 Nm | ||
| 3AZ Pulley (ribbed drive belt) | Alternator with cooling jacket | 80 Nm | ||
| all others | 70 Nm | |||
| N42, N46 Valeo | 75 Nm | |||
| N42, N46 Bosch | 65 Nm | |||
| 4AZ Rear holder | All | 3.5 Nm | ||
| 5AZ Fillister head screw for wire holder | All | 3.5 Nm | ||
| 6AZ Alternator on bearing block | M40/M42/M43/M44 | 43 Nm | ||
| 7AZ Alternator to crankcase | N42, N46, N62 | M8 | 21 Nm | |
| 8AZ Belt pulley (ribbed V-belt) with freewheel (Ina) fitted to Bosch and Valeo alternators | N42, N43 | 80 Nm |