Extractor MW

WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: (Universal extractor Kukko 17/K) For pulling bearing inner race from drive flange on wheel bearing, rear

Consisting of:

1 = 0490483 Spindle

NOTE: (Pressure spindle with bridge)

2 = 0490484 Spindle

NOTE: (Adjusting spindle (2 pieces) with knurled nuts (4 pieces))

3 = 0490485 Spindle

NOTE: (Pressure spindle, side)

4 = 0490486 Retaining bracket

NOTE: (Adjusting jaws (2 pieces))

5 = 0490487 Bolt

NOTE: (Adjusting screws (2 pieces) with nut) For adjusting jaw (2 pieces)

Fig 1: Identifying Extractor (00-7500)

Courtesy of BMW OF NORTH AMERICA, INC.

6 = 0490488 Extension

NOTE: (Extension (2 pieces))

7 = 0490489 Bridge