41 00... Procedure for vehicles with active pedestrian protection (AFGS) after an accident: Notes
WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.
The AFGS system consists of the following components:
- Satellites (control unit + sensor)
- Sensors, inside, bumper trim, left/middle/right
- ACSM control unit (Crash Safety Module)
- Cables and connectors
- Engine compartment lid hinges
- Actuator
- Engine compartment lid hinge
- Engine compartment lid catch
- Catch, engine compartment lid
- Catch, upper section (striker)
In case of a frontal or side collision in the area of the engine compartment lid and/or the A-pillars, check the following components:
Satellites (control unit + sensor)
- Procedure
- Read fault memory
- Disconnect battery and observe waiting period
- Rectify faults
- Reconnect battery and observe waiting period
- Delete fault memory
- Turn off ignition and wait at least 2 minutes (no consumers may be switched on during this period such as e.g. interior lights, radio, etc.)
- Switch on ignition.
- Clear fault memory and if necessary rectify faults
Cables and connectors
- Procedure
- Check cables and connectors for damage, replace if necessary.