65 77 534 Removing and installing/replacing front right sensor (US version only)
WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove FRONT RIGHT WHEEL ARCH TRIM
NOTE:
This operation depends on the engine version.
Release screw (1) on auxiliary radiator bracket (2).
Remove auxiliary radiator bracket (2) and carefully place to one side.
Installation:
Auxiliary radiator bracket (2) must be correctly seated in the designated guides.
Release screws (1).
Tightening torque 65 77 2AZ .
Feed out acceleration sensor (2).
Unlock plug connection (3) and disconnect.
Installation:
Make sure acceleration sensor (2) is in correct installation position.
Sensor surface of acceleration sensor (2) must point upwards!
Plug connection (3) must point in opposite direction to direction of travel.