52 25 059 Removing and installing/replacing valve block for lumbar support
WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary work:
- Partially remove LEFT OR RIGHT REAR SEAT BACKREST
Release rear seat backrest only and move forwards
Unfasten plug connection (1) and disconnect.
Remove valve block in direction of arrow.
Detach air hoses from valve block.
- (2) Outlet, upper lumbar cushion
- (3) Outlet, lower lumbar cushion
- (4) Supply line from massage pump
NOTE:
Gently heat the air hoses if too tightly seated on the valve housing.