Trimming bumper panel to size

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.

Remove BUMPER PANEL .

Mark points (A to D) on left and right of untrimmed bumper panel (1).

Measurements are taken from the slats of the ornamental grille (2).

= 65 mm
= 65 mm
= 75 mm
= 90 mm

Fig 1: Identifying Ornamental Grille Measurements
Courtesy of BMW OF NORTH AMERICA, INC.
= Perpendicular to point (D)

Connect points (A to E) and cut out area (1).

Place front spoiler on cut bumper panel and check for accuracy of fit; if necessary, rework bumper panel.

After completion of work, deburr the cutting edges.

BUMPER PANEL must now be attached.

Fig 2: Identifying Connect Points (A To E) And Cut Out Area

Courtesy of BMW OF NORTH AMERICA, INC.