LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2016 >> Z4 sDrive35is >> Repair and Diagnosis >> External Pages >> Different car >> Section 268 (Wheel And Tires - Repair - F01/F02) >> Disc Wheels (Rims) >> 36 11 533 Removing and installing/replacing a tire pressure control electronic wheel module (Generation I) >> Removing electronic wheel module

Removing electronic wheel module

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.

Release Torx socket screw (1) and remove electronic wheel module (2).

Fig 1: Identifying Torx Socket Screw And Electronic Wheel Module
G06890138Courtesy of BMW OF NORTH AMERICA, INC.

Release union nut with special tool 00 2 190; if necessary, grip valve insert (1) at cylindrical section of ball head.

Remove valve insert from rim.

Fig 2: Release Union Nut Using Special Tool (00 2 190)
G06890139Courtesy of BMW OF NORTH AMERICA, INC.

Remove washer (1).

Fig 3: Identifying Washer
G06890140Courtesy of BMW OF NORTH AMERICA, INC.
IMPORTANT: Before the installation of new wheel electronics with valve, thoroughly clean the valve bore of the wheel rim!
Also make sure that the valve bore is free of burrs
scientia non olet · About LEMON Manuals