64 11 865 Replacing actuator drive for recirculated air flap (vehicles with N55 engine): Notes

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary work:

Remove RIGHT/REAR SUSPENSION CROSS-BRACE

Unlock and disconnect all plug connections.

Unlatch connector housing (1 and 2) from guide of auxiliary E-box (3).

Fig 1: Identifying Connector Housing From Guide Of Auxiliary E-Box

G09881448

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Carefully unlock retaining hook (2) while lifting E-box3 and simultaneously pulling forward

Installation note:

Ensure guide lug (2) sit correctly in the respective recesses of the fan housing.

Fig 2: Identifying Retaining Hook, Guide Lug And Screw

G09881449

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connection (1) on automatic air recirculation control sensor (2) and disconnect.

Fig 3: Identifying Plug Connection On Automatic Air Recirculation Control Sensor

G06886219

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) on fan housing cover (2).

Lift out fan housing cover.

Fig 4: Identifying Fan Housing Cover Screws

G06886220

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Unclip relay lever (2) with a suitable tool.

Remove actuator drive (3).

Unlock plug connection (4) and disconnect.

Fig 5: Identifying Actuator Drive, Relay Lever, Plug Connection And Screws

G06886221

Courtesy of BMW OF NORTH AMERICA, INC.