34 35 001 Replacing a brake pad sensor (rear)

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT:

The brake pad wear sensor must be replaced once it has been removed (brake pad wear sensor loses its retention capability in the brake pad).

If an already ground brake pad wear sensor has to be replaced although the MINIMUM BRAKE PAD THICKNESS has not yet been reached, it is necessary to grind down the new sliding contact with a file to the same length as the ground sliding contact.

Necessary preliminary work:

Remove rear right WHEEL

Open housing cover.

Disconnect plug connection (1).

Fig 1: Identifying Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip line (1) along line.

Fig 2: Identifying Unclip Line

Courtesy of BMW OF NORTH AMERICA, INC.

Disengage line from brake pad wear sensor from holder (1).

Pull brake pad wear sensor (2) in direction of arrow out of brake pad.

Installation note:

Make sure brake pad wear sensor (2) is correctly seated in brake pad and holder (1).

Fig 3: Identifying Brake Pad Wear Sensor And Holder

Courtesy of BMW OF NORTH AMERICA, INC.