61 31 221 Removing and installing/replacing both multifunction steering wheel switches

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary work:

Remove AIRBAG UNIT

Release screws (1) on left/right on back of steering wheel (2).

Fig 1: Identifying Steering Wheel Back With Screw

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Both multifunction steering wheel switches (1) are connected to each other by the wiring harness (2).

Feed wiring harness (2) out of steering wheel.

Remove both multifunction steering wheel switches (1) in direction of arrow.

Fig 2: Removing Multifunction Steering Wheel Switches

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1) and remove both multifunction steering wheel switches (2).

Installation note:

Make sure electrical wiring is correctly routed.

Fig 3: Identifying Multifunction Steering Wheel Switch With Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.