61 31 008 Removing and installing steering column switch cluster
WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Move wheels into straight-ahead position and do not alter this position during the repair work.
Do not under any circumstances turn the steering column switch cluster when the steering wheel is removed.
Necessary preliminary work:
- Remove steering wheel. See REMOVING STEERING WHEEL or REMOVING SPORT STEERING WHEEL .
Unclip steering column shroud upper and lower sections (1).
Unfasten screws (2).
Tightening torque 61 31 3AZ .
Remove steering column switch cluster (3) in direction of arrow.
Installation note:
Carry out STEERING ANGLE SENSOR ADJUSTMENT .
On vehicles with active steering, steering angle sensor adjustment is performed by means of START-UP /adjustment of active steering.
Disconnect plug connection (1).
Remove steering column switch cluster (2).
Replacement:
- Carry out VEHICLE PROGRAMMING/ENCODING
- Carry out STEERING ANGLE SENSOR ADJUSTMENT
- Vehicles with active steering:
- Steering angle sensor is adjusted by means of INITIAL OPERATION/ADJUSTMENT of active front steering
- If necessary, proceed in accordance with instructions