61 67 100 Removing and installing/replacing left high-pressure nozzle of headlight washer system

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary work:

Remove FRONT BUMPER TRIM

To prevent excess escape of washer fluid, seal off end of high pressure line with special tool 13 3 010 .

Fig 1: Sealing High Pressure Line End Using Special Tool (13 3 010)

G06895145

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock high pressure line (1) and detach from high-pressure nozzle (2).

Fig 2: Identifying High Pressure Line With Nozzle

G06895146

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock high-pressure nozzle (1) and remove in direction of arrow towards rear.

Fig 3: Removing High-Pressure Nozzle

G06895147

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Ensure guide (1) is correctly seated.

New washer jets are already preset.

Carry out function check.

Fig 4: Identifying Washer Jets Guide

G06895148

Courtesy of BMW OF NORTH AMERICA, INC.