61 35 360 Removing and installing/replacing control unit for camera-based driver assistance systems (KAFAS)

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks:

Clamp off BATTERY NEGATIVE LEAD
Remove TRIM PANEL FOR PEDAL ASSEMBLY

Disconnect plug connection (1).

Release screw (2).

Tightening torque 61 35 2AZ .

Pull control unit (3) out of equipment carrier (4) in direction of arrow.

Installation:

Make sure control unit (3) is correctly installed in equipment carrier (4).

Fig 1: Pulling Control Unit Out Of Equipment Carrier

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out PROGRAMMING/ENCODING .

Carry out calibration:

Service function
Body
Display and information functions
Camera-based driver assistance system
Calibration of lane departure warning