61 35 127 Removing and installing/replacing body gateway module
WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION)
.
Read out PROGRAMMING/ENCODING .
- Print out and make a note of settings for Car&Key Memory in CKM menu
Necessary preliminary work:
- Disconnect NEGATIVE BATTERY CABLE
- Remove TRIM PANEL FOR PEDAL MECHANISM .
Disconnect plug connection (1).
Release screw (2) and remove cable shoe (4).
Tightening torque 61 35 3AZ .
Pull body module (3) out of equipment holder (5) in direction of arrow.
Installation note:
Make sure body module (3) is correctly installed in equipment holder (5).
Replacement:
Carry out PROGRAMMING/ENCODING .
Perform FlexRay synchronization via path:
- Body
- Central Gateway Module
- Initialize FlexRay
Check printed-out or noted-down settings for car and key memory in CKM menu and reset if necessary