61 12 062 Replacing wiring harness for front bumper
WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on HANDLING WIRING HARNESSES
and cables.
Necessary preliminary tasks:
- Remove FRONT BUMPER TRIM .
Disconnect plug connections (1) on five ultrasonic transducers.
Unclip wiring harness (2) from bumper trim.
Remove wiring harness (2).
Remove PDC. See REMOVING FRONT LEFT ULTRASONIC SENSOR ; REMOVING FRONT RIGHT ULTRASONIC SENSOR ; REMOVING CENTER FRONT LEFT ULTRASONIC SENSOR ; REMOVING CENTER FRONT RIGHT ULTRASONIC SENSOR ; and REMOVING FRONT CENTER ULTRASONIC SENSOR .
Installation:
Make sure wiring harness (2) is laid correctly.