33 55 000 Removing and installing/replacing rear anti-roll bar

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove both ANTI-ROLL BAR LINKS FROM ANTI-ROLL BAR

Release screws (1).

Tightening torque 33 55 1AZ .

Installation note:

Replace screws.

Turn anti-roll bar (2) and remove sideways.

Fig 1: Identifying Screws And Anti-Roll Bar

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Check BOTH RUBBER MOUNTS FOR DAMAGE and replace if necessary.
Pay attention to correct installation position when installing anti-roll bar.
The bend of the anti-roll bar must point upwards in the anti-roll bar to anti-roll bar link area.