33 32 051 Removing and installing/replacing left or right anti-roll bar link/integral link: Notes
WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If the integral link is detached from the swinging arm, it is necessary after installation to carry out a chassis/wheel alignment check.
Necessary preliminary work:
- Remove REAR WHEEL .
Release nut (1) and remove screw.
Tightening torque 33 32 4AZ .
Release screw (2) and remove integral link (3).
Tightening torque 33 32 5AZ .
Installation note:
Replace screw and nut.
Tighten screw connections in NORMAL POSITION .