Storage Location

WARNING: This page is about a different car, the 2018 BMW X4, 2017 BMW X4, 2016 BMW X4, and 2015 BMW X4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Device (311000)

Courtesy of BMW OF NORTH AMERICA, INC.

Consisting of:

1 = 0491851 Spindle

NOTE: With 2 nuts and 2 washers

2 = 0491852 Bush

NOTE: (Slip bush) For installing the rubber mount in the front axle support

3 = 0491853 Bush

NOTE: (Bush) For removing the rubber mount from the front axle support, for removing and installing the rubber mount in the wishbones and for press-fitting the taper roller bearing of the rear axle differential housing

4 = 0491854 Pipe

NOTE: (Support tube) For installing the rubber mount in the front axle support - series: E12

5 = 0491855 Washer

NOTE: (Flanged washer) For centering of threaded spindle and as a support disc for removing and installing the rubber mount in the front axle support and in the wishbones - series: E12

6 = 0491856 Synchronizing key

NOTE: For removing and installing the rubber mount in the front axle support - series: E12

7 = 0491857 Bush

NOTE: For installing the rubber mount in the front axle support - series: E12

8 = 0491858 Bush

NOTE: (Bush) For installing the rubber mount in the front axle support and thrust piece, for removing and installing the rubber mount in the wishbones

9 = 0491859 Bush

NOTE: (Bush) Deletion, only available via tool set