51 47 065 Removing and installing/replacing cover at front left or right entrance
Special tools required:
IMPORTANT:
Risk of damage!
Do not raise cover (2) over entire length simultaneously.
Unclip clips (1) for cover (2) with special tool 00 9 317 .
Remove cover (2).
Installation:
Lever out remaining clips (1) in retaining holes with a suitable tool.
If necessary, slide missing clips (1) into clip mounts of cover.
Clip cover into retaining holes.
NOTE:
Clips (1), clip mounts and retaining lugs of cover must not be damaged.
If necessary, replace faulty clips (1) or cover.