63 12 895 Replacing electronics box/control unit for left/right adaptive headlight

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

WARNING: Version with xenon headlights: Danger to life due to high voltage! Therefore disconnect all components from voltage supply before removal.
Work on the entire xenon lighting system (ignition device, control unit and bulb) may only be carried out by qualified personnel.

Necessary preliminary tasks:

Remove FRONT WHEEL ARCH COVER

NOTE: For purposes of clarity, picture shows component removed.

Release screws (1).

Remove electronics box/control unit for adaptive headlight (2) from headlight (3).

Fig 1: Identifying Adaptive Headlight Drive/Electronic Box With Mounting Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

During installation, make sure sealing cup (1) is fitted correctly.

Make sure pin housing (2) is fitted correctly.

Fig 2: Identifying Sealing Cup And Pin Housing

Courtesy of BMW OF NORTH AMERICA, INC.

Carry out VEHICLE PROGRAMMING/CODING .