1290 E-BOX (X6 sDrive 35i, X6 xDrive 35i)
1290 ELECTRONICS BOX, WIRING HARNESS (N55) - TIGHTENING TORQUE SPECIFICATION
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Cable channel to cylinder head cover | N55 | 5 Nm | ||
| 2AZ Earth cable to crankcase lower section | N55 | M8 | Replace aluminum screw. Joining torque Angle of rotation |
8 Nm 45° |
| 3AZ Earth cable to rear cylinder head | N55 | M6 | 8 Nm | |
| 4AZ Cable channel to engine block | N55 | M6 | Replace aluminum screws. | 8 Nm |
| 5AZ Ground cable for ignition coils | N55 | 5 Nm | ||
| 6AZ Bracket for connector, oxygen sensor, to cylinder head cover | N55 | 8 Nm |