61 35 245 Removing and installing (replacing) bottom sensor line for contactless tailgate opening (X6 2015-2019)
CAUTION:
Observe the INFORMATION ON PROTECTION FROM ELECTROSTATIC DISCHARGE .
Necessary preliminary work:
- Remove REAR BUMPER TRIM .
CAUTION:
Risk of damage, do not kink sensor line!
Unlock and disconnect connector (1).
Feed out connecting line (2).
Unclip sensor line (3).
Installation note:
Make sure plug connector (1) and sensor line (3) are correctly seated.
Make sure connecting line (2) is correctly laid.
CAUTION:
Risk of damage, do not kink sensor line!
Unclip the sensor line (1) and remove.
Installation note:
Make sure sensor line (1) is correctly seated.