11 61 065 Removing and installing/replacing left intake plenum (N63) (X6 xDrive 50i)

Necessary preliminary tasks: 

• Remove the engine with FRONT AXLE .
• Remove left THROTTLE VALVE .

Disconnect plug connection (1) at servomotor for eccentric shaft (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip wiring harness from clamps (1).

Disconnect plug connection (2).

Release screws (3).

Tightening torque: 13 62 2AZ .

Remove pressure sensor (4).

Installation note: 

Replace O-ring.

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew nuts (1).

Tightening torque: 11 61 1 AZ .

Remove intake plenum (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Replace all sealing rings (1).

Observe mounting pin on the differentiated air intake system.

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine and vehicle.

Check air intake system for leaks with diagnosis system.

1. DME.
2. Air supply.
3. Charging pressure control.
4. (ATL) exhaust turbocharger procedure.