35 11 000 Removing and installing (replacing) complete bearing block for foot pedal (X6 2015-2019)

CAUTION: After completion of work, carry out function check.

Necessary preliminary work:

Disconnect plug connection (1).

Remove retaining clip (2) and pull out locking pin in direction of arrow.

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew nuts (1).

Installation note:

Replace self-locking nuts.

Tighten nuts (1) such that bearing support can still be moved.

Make sure bearing support is correctly seated on body.

Tighten down nuts (1).

Tightening torque 35 11 1AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip retaining bracket (1) and remove both brake lines (2) from guides.

CAUTION: Do not bend brake lines.

Pull tandem brake master cylinder with brake servo 30 mm forwards.

Installation note:

Retighten brake lines on tandem brake master cylinder.

Tightening torque 34 32 1AZ .

Feed out bearing support for pedal mechanism.

Replacement:

Courtesy of BMW OF NORTH AMERICA, INC.