34 32 881 Replacing front left or right brake hose (X6 2015-2019)
Necessary preliminary tasks:
- Remove WHEEL .
- Read and comply with GENERAL INFORMATION .
After completing repair work: BLEED BRAKING SYSTEM .
Press brake pedal down to floor and secure with pedal support.
NOTE:
The pedal support may only be released when the brake lines are reconnected.
This prevents brake fluid from emerging from the expansion tank and air from entering the system when the brake lines are opened.
This prevents brake fluid from emerging from the expansion tank and air from entering the system when the brake lines are opened.
Detach clamp (1) from holder on spring strut in top direction.
Installation note:
clamp (1) must be felt and heard to snap into place.
Ensure correct fit in guide.
IMPORTANT:
Grip brake hose at square head (2) so that connecting piece cannot rotate in retaining bracket.
Disconnect brake hose from brake line (1).
Installation note:
Tightening torque 34 32 1AZ .
Detach brake hose from brake caliper (1).
Installation note:
Tightening torque 34 32 2AZ .
IMPORTANT:
First tighten brake hose on brake caliper.
Move wheels into straight-ahead position.
Insert brake hose in bracket and screw onto brake pipe.
Never twist brake hose when installing it and avoid all contact with parts attached rigidly to the body.
Move wheels into straight-ahead position.
Insert brake hose in bracket and screw onto brake pipe.
Never twist brake hose when installing it and avoid all contact with parts attached rigidly to the body.