51 47 315 Removing and installing/replacing carpet for vehicle interior (X6 2015-2019)
Necessary preliminary tasks:
- Disconnect BATTERY NEGATIVE LEAD .
- Remove both front seats. Refer to 52 14 001 REMOVING AND INSTALLING FRONT SEAT DRIVER'S SIDE (NORMAL, ELECTRICAL) REP-REP-RAF1552-5214001 - V.3 (X6 2015-2019) and 52 14 002 REMOVING AND INSTALLING FRONT PASSENGER SEAT (NORMAL, ELECTRIC) REP-REP-RAF1552-5214002 - V.3 (X6 2015-2019) or 52 13 001 REMOVING AND REFITTING DRIVER'S SEAT REP-REP-RAF1552-5213001 - V.3 (X6 2015-2019) and 52 13 002 REMOVING AND REFITTING FRONT PASSENGER SEAT REP-REP-RAF1552-5213002 - V.3 (X6 2015-2019) or 52 17 001 REMOVING AND INSTALLING FRONT SEAT, DRIVER'S SIDE (COMFORT) REP-REP-RAF1552-5217001 - V.5 (X6 2015-2019) and 52 17 002 REMOVING AND INSTALLING FRONT SEAT, PASSENGER'S SIDE (COMFORT) REP-REP-RAF1552-5217002 - V.5 (X6 2015-2019) or 52 16 001 REMOVING AND INSTALLING FRONT SEAT, DRIVER'S SIDE (SPORT, ELECTRICAL) REP-REP-RAF1552-5216001 - V.5 (X6 2015-2019) and 52 16 002 REMOVING AND INSTALLING FRONT SEAT, PASSENGER'S SIDE (SPORT, ELECTRICAL) REP-REP-RAF1552-5216002 - V.5 (X6 2015-2019) .
- Remove ACCELERATOR PEDAL MODULE .
- Remove CENTER CONSOLE .
- Remove TRIM PANEL FOR PEDAL MECHANISM .
- Remove lower INSTRUMENT PANEL TRIM .
- Remove COVER FOR CENTRAL BASS SPEAKER left/right.
- Remove front left/right footwell side trim panel. Refer to 51 43 070 REMOVING AND INSTALLING/REPLACING SIDE TRIM PANEL, FOOTWELL, ON A-PILLAR, LEFT REP-REP-RAF1651-5143070 - V.2 (X6 2015-2019) and 51 43 075 REMOVING AND INSTALLING/REPLACING SIDE TRIM PANEL, FOOTWELL, ON A-PILLAR, RIGHT REP-REP-RAF1651-5143075 - V.2 (X6 2015-2019) .
IMPORTANT:
Risk of damage!
Pay attention to cables when cutting.
Start cuts towards center of vehicle as far as is possible. This guarantees that cutting edges are covered by storage compartment and/or dashboard.
Pay attention to cables when cutting.
Start cuts towards center of vehicle as far as is possible. This guarantees that cutting edges are covered by storage compartment and/or dashboard.
Cut out carpet along lines (1).
Remove carpet to the rear/top and feed out cable.
Installation note:
Apertures (1) serve as fixing points for fitting carpet.
Replacement:
Lay removed carpet over new one and transfer cuts to new carpet.
Remount STORAGE NET , if necessary.