51 42 060 Removing and installing/replacing armrest in rear door, left or right (X6 2015-2019)

Necessary preliminary tasks:

REMOVE rear door handle

NOTE: Armrest is welded to door trim panel only on initial installation. The armrest is screw-connected on second installation. If applicable, release screws instead of welding spots.

IMPORTANT: Risk of damage!
To avoid damaging the contact surface, only drill to base area of door trim panel.

Drill out all marked welding spots on door trim panel with 8 mm diameter weld spot drill bit.

Remove welding remains on door trim panel with scalpel (for heavy duty use).

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Saw off welding pins (1) along molding (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Insert armrest in door trim panel.

Welding pins (1) are not to protrude over door trim panel (2).

Secure armrest with repair screws (3).

Courtesy of BMW OF NORTH AMERICA, INC.