63 11 560 Removing and installing/replacing the headlight driver module (X6 2015-2019)
WARNING:
Version with xenon lighting system: Danger to life due to high voltage! Disconnect all components from voltage supply before removal.
Work on the entire xenon lighting system (ignition device, control unit and bulb) may only be carried out by qualified personnel.
Work on the entire xenon lighting system (ignition device, control unit and bulb) may only be carried out by qualified personnel.
IMPORTANT:
Follow NOTES ON PROTECTION FROM ELECTROSTATIC DISCHARGE
!
Unlock and disconnect the connector (1).
Unfasten screws (2).
Tightening torque 63 11 2AZ .
Pull headlight driver module (3) out of headlight in direction of arrow.
Installation note:
Gasket (1) must not be damaged and must be installed free from grease.
Guides must not be damaged or missing.
Replacement:
Teach in headlight driver module (1) via vehicle diagnosis.
- Service functions
- Body
- Lights
- Initialize the headlight driver module and teach in LEDs in headlight
- If necessary, perform encoding