Adjusting dynamic light spot headlight (with non-electronic headlight adjustment device) (X6 2015-2019)
COMPLY WITH TEST PREREQUISITES FOR HEADLIGHT ADJUSTMENT .
FUNCTIONAL DESCRIPTION OF DYNAMIC LIGHT SPOT .
Refer to the operating instructions for the headlight adjustment device!
NOTE:
Dynamic Light Spot headlight must be adjusted in the following cases:
- After removing and installing/replacing the Dynamic Light Spot headlight
- After removing and installing/replacing the front bumper panel
- In the event of customer complaints about the lighting performance
Switch the ignition on.
Perform test procedure via path:
- Body
- Lights
- Adjust targeted illumination (GZA)
Adjust headlight setting dimension on headlight adjustment device: 0 %
NOTE:
The graphic schematically shows the light pattern of the dynamic spot headlight on the projection surface in the inspection glass of a headlight adjustment device.
The proportions shown in the graphic are examples and may differ from a real pattern.
- horizontal line = dividing line for reference axis of light/dark boundary for the low-beam headlight
- vertical line = break point of light/dark boundary for the asymmetric low-beam headlight
Light pattern of dynamic spot headlight must be positioned as follows:
- 1/3 must lie above and 2/3 below the horizontal line (1).
- Vertical line (2) must be in the middle.
If necessary, adjust headlights for targeted illumination.