51 23 211 Removing and installing/replacing pull cable for hood/bonnet locks at front (X6 2015-2019)

Necessary preliminary tasks: 

• Remove the engine compartment lid catch on the left and right. Refer to 51 23 110 REMOVING AND INSTALLING/REPLACING LEFT ENGINE COMPARTMENT LID LOCK. REP-REP-RAF1551-5123110 - V.5 (X6 2015-2019)  and 51 23 100 REMOVING AND INSTALLING/REPLACING RIGHT ENGINE COMPARTMENT LID LOCK. REP-REP-RAF1551-5123100 - V.5 (X6 2015-2019) .

Unclip clutch housing Bowden cable (1) at marked points.

Installation note: 

Clips must not be damaged.

To open up clutch housing cover, lever up cover (2) in direction of arrow.

Courtesy of BMW OF NORTH AMERICA, INC.

Feed rear Bowden cable (2) out of holder (1) and clutch housing (3).

Courtesy of BMW OF NORTH AMERICA, INC.