66 20 517 Removing and installing/replacing a front center left (inside) ultrasonic transducer (Park Distance Control) (X6 2015-2019)
Necessary preliminary work
- Remove FRONT BUMPER PANEL .
Unfasten plug connection (1) and disconnect.
Unlock latch mechanisms (2) and pull ultrasonic sensor (3) out from holder.
Installation note:
Before installation of ultrasonic sensor (3) on wiring harness, clean plug connection!
Retaining tabs (2) must not be damaged!
Make sure ultrasonic sensor is securely seated.
Installation note:
Make sure rubber ring (1) is correctly seated on ultrasonic sensor (2).