Removing and installing/replacing high-pressure nozzle of headlight cleaning system on left (or right) (X6 M)
Special tools required:
- 00 9 340
Use special tool 00 9 340 to lift the cover (1).
Slowly pull out high-pressure jet of headlight washer system from cover (1).
Unclip cover (2) from guide (1) at the side in direction of arrow and remove to the front.
Allow high-pressure nozzle of headlight washer system (3) to slide back slowly.
Press both catches (1) outwards and pull high-pressure jet (2) out of holder.
Unfasten and disconnect hose connection from high-pressure jet.
Installation note:
Keep hose connection for high-pressure jet (2) and high-pressure line clean and free from grease.
Make sure high-pressure line is correctly engaged on high-pressure jet (2).
If necessary, top up washer fluid.