Removing and installing/replacing left or right lashing rail in luggage compartment floor (X6 M)
Necessary preliminary tasks:
- Remove LUGGAGE COMPARTMENT FLOOR TRIM PANEL .
Removal:
Release clamps (1).
Unfasten screws (2 and 3).
Feed out lashing rail (4) towards the inside and remove it.
Installation:
NOTE:
Mask trim on the tail panel around the rail to prevent scratches.
IMPORTANT:
Risk of mixing up
Different screws fitted.
Feed in lashing rail (4).
Fasten clips (1).
Tighten down screws (2 and 3).
Tightening torque 51 71 15AZ .
Required follow-up work:
- Install LUGGAGE COMPARTMENT FLOOR TRIM PANEL .