Replacing rear left or right brake hose (X6 M)
NOTE:
Read and comply with GENERAL INFORMATION .
After completing work: BLEED BRAKE SYSTEM .
After completing work: BLEED BRAKE SYSTEM .
Press brake pedal down to floor and secure with pedal support.
NOTE:
The pedal support may only be released when the brake lines are reconnected.
This prevents brake fluid from emerging from the expansion tank and air from entering the system when the brake lines are opened.
This prevents brake fluid from emerging from the expansion tank and air from entering the system when the brake lines are opened.
Detach retaining clamp (1) in direction of arrow.
Installation note:
Retaining clamp must be felt and heard to snap into place.
IMPORTANT:
Grip brake hose at square head (3) to prevent connector from turning in retaining bracket.
Detach brake hose from brake line (2).
Installation note:
Tightening torque 34 32 1AZ .
Detach brake hose from brake caliper (1).
Installation note:
Tightening torque 34 32 3AZ .
IMPORTANT:
Never twist brake hose when installing it and avoid all contact with parts attached rigidly to the body.
NOTE:
First tighten brake hose on brake caliper.
Insert brake hose in bracket and screw onto brake pipe.
Insert brake hose in bracket and screw onto brake pipe.