Removing and installing/replacing front left or right deformation element for bumper (X6 M)

NOTE: Work is described for left deformation element.

Necessary preliminary tasks:

Pedestrian protection sensor must be checked and/or replaced after airbag deployment.

Unscrew bolt (1) on right headlight.

Tightening torque 63 12 1AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Pull out cover (1) on left and right.

Courtesy of BMW OF NORTH AMERICA, INC.

Slacken nut (1).

Tightening torque 51 11 11AZ .

Unscrew bolt (2) and remove support (3).

Tightening torque 51 11 12AZ .

NOTE: Carry out work on the left side in the same way as for the right side illustrated here.

Courtesy of BMW OF NORTH AMERICA, INC.

Right side only:

Release screws (4).

Diesel versions only:

Release screws (5).

Release screws (1).

NOTE: Carry out work on the left side in the same way as for the right side illustrated here.

Courtesy of BMW OF NORTH AMERICA, INC.

Left side:

Unlock plug connections (1) and disconnect.

Unclip wiring loom from support member if necessary.

Unfasten screws (2).

Tightening torque 51 11 5AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten plug connection (1) and disconnect.

Unfasten any other cable retainers as necessary.

Maneuver out front panel complete with air duct (2), support member (3) and deformation element (4).

Courtesy of BMW OF NORTH AMERICA, INC.

Undo screws (1) from rear.

Remove air duct (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew bolts (1) and remove support member from deformation element.

Tightening torque 51 11 4AZ .

Unscrew nut (2) and remove twin-tone horn and bracket.

Unscrew bolts (3) and remove bracket from deformation element.

Tightening torque 51 11 6AZ .

Remove fixings (4).

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew bolts (5) and remove sensor from bracket.