11 00... Engine oil change (N57)
Carry out work on the vehicle only when wearing oil- and heat-resistant protective gloves including forearm protection, face guard and protective apron.
Carry out engine oil service only when the engine is at operating temperature.
Observe the exact engine oil filling capacity.
Overfilling the engine with engine oil will result in engine damage.
Risk of damage!
When working on the engine oil, coolant or fuel circuit, it is essential always to protect the alternator against dirt contamination.
Cover alternator with suitable materials.
Recycling:
Catch and dispose of drained engine oil in a suitable collecting vessel.
Observe country-specific waste disposal regulations.
Release oil filter cover (1) with a suitable tool.
Unlock and open lid (1)
Note: Risk of shorting at starter motor!
Open oil drain plug (1) of oil sump and drain engine oil.
Tightening torque 11 13 1AZ .
Installation note:
Replace sealing ring.
Pull out oil filter element (2) in direction of arrow.
Installation note:
Replace oil filter element (2) and sealing ring (1).
Secure oil filter cover (1) with a suitable tool.
Tightening torque 11 42 1AZ .
Start engine and run at idle until oil pressure indicator light goes out.
Switch off engine.
Check oil filter cover (1) and screw plug on oil sump for tightness.
Assemble engine.
Checking oil level:
- Park vehicle on a horizontal surface
- Using the oil dipstick, check the engine oil level after five minutes on the engine at operating temperature
- Top up engine oil if necessary