Removing and installing/sealing rear coolant end cover (N63T2) (X5 M)

Special tools required:

WARNING: Risk of scalding!
Only perform this work after engine has cooled down.

Recycling:

Catch and dispose of drained coolant in a suitable container.

Observe country-specific waste disposal regulations.

Necessary preliminary tasks:

Release all screws in area (1).

Tightening torque 11 14 5AZ .

Remove end cover.

NOTE: Clean sealing surfaces with special tool 11 4 470.

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Replace profile seal (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.