11 22 500 Removing and installing/replacing flywheel (N55)
Special tools required:
IMPORTANT:
Aluminum screws/bolts must be replaced each time they are released.
Aluminum screws/bolts are permitted with and without color coding (blue).
For reliable identification:
Aluminum screws/bolts are not magnetic.
Jointing torque and angle of rotation must be observed without fail (risk of damage).
Aluminum screws/bolts are permitted with and without color coding (blue).
For reliable identification:
Aluminum screws/bolts are not magnetic.
Jointing torque and angle of rotation must be observed without fail (risk of damage).
Necessary preliminary tasks:
- Remove transmission . See 24 00 033 REMOVING AND INSTALLING AUTOMATIC TRANSMISSION (GA8HP45Z) N55 .
Automatic transmission:
Secure flywheel (1) with special tool 11 9 260 .
Unfasten flywheel bolts.
Tightening torque: 11 22 1AZ .
Installation note:
Flywheel (1) is secured with an dowel pin.
Manual gearbox:
Fasten dual-mass flywheel with special tool 11 9 260 and 11 9 265 .
Release flywheel bolts with special tool 11 4 180 /
Tightening torque: 11 22 2AZ .
Installation note:
Fit new flywheel bolts.
Clean all threads for flywheel bolts in crankshaft.
Installation note:
Pay attention to dowel pin.
Installation note:
Ensure installed position of magnet wheel is correct.
Assemble engine.