26 11 090 Removing and installing/replacing front centring mount for propeller shaft

Special tools required:

Necessary preliminary tasks:

Completely fill centring bore hole (1) with viscous grease.

Drive special tool 11 1 310 with a plastic hammer into centring bore hole.

The centring bearing (1) is forced out of the propeller shaft by the pressure on the grease filling.

If necessary, top up grease repeatedly.

NOTE: To drive out the bearing, you can also fill the centring bore hole with water instead of grease.

Fig 1: Identifying Special Tool (11 1 310)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Remove grease or water from mount bore.

Drive in centring mount (1) with special tools 11 2 030 and 00 5 500 into propeller shaft (observe protrusion).

Grease centring mount.

Grease, see DRIVESHAFT -- OPERATING FLUIDS .

Fig 2: Identifying Special Tools (11 2 030 And 00 5 500) Into Propeller Shaft
Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Observe protrusion A = 4⁺² mm of centring (1).

Fig 3: Identifying Protrusion Of Centering

Courtesy of BMW OF NORTH AMERICA, INC.