51 47 490 Removing and installing/replacing underbody protection (front)

NOTE: Picture for example purposes. There may be differences in detail in the case of other models.

Removal:

Loosen screws.

Pull forward underbody protection (1) below bumper cover (2) and remove.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Feed in underbody protection (1) below bumper cover (2) and position at screw points.

Secure underbody protection (1) with bolts.

Tightening torque 51 71 5AZ .

Courtesy of BMW OF NORTH AMERICA, INC.