67 62 020 Removing and installing/replacing flat motor for rear left or right power window regulator

Necessary preliminary tasks:

Release screws (1) and detach flat motor (2) from power window regulator.

Tightening torque 67 62 1AZ .

Fig 1: Identifying Flat Motor From Power Window Regulator And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: For installation of flat motor (3) without tension, fit pinion (2) in guide (1)!

Fig 2: Identifying Flat Motor, Pinion And Guide

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

An initialization must be carried out in order to activate anti-trap mechanism.

Read and comply with NOTES on initialization of power window regulator.