LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2016 >> M5 Standard Trans >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine - Variable Valve Timing Control System (VANOS), Intake Plenum, Turbocharger, Water Pump, Thermostat, Coolant Lines, EGR Valve, EGR Cooler, Oxygen Sensors - Repair >> Intake Plenum >> N52 Engine >> 11 61 050 Removing and installing intake air manifold (N52)

11 61 050 Removing and installing intake air manifold (N52)

Necessary preliminary work: 

Open holder (2).

Disconnect plug connection (1) under of intake plenum.

Release engine ventilation from cylinder head cover.

Fig 1: Identifying Plug Connection, Holders And Crankcase Breathers
G04751268Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Disconnect plug connection (3).

Release screws (4).

Detach engine wiring harness (2) from intake plenum and lay to one side.

For purposes of clarity, graphic shows intake plenum removed (E92).

Fig 2: Engine Wiring Harness, Screws And Plug Connections
G04751269Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1) on oil pressure switch (2).

Fig 3: Identifying Plug Connection On Oil Pressure Switch
G04751376Courtesy of BMW OF NORTH AMERICA, INC.

Release fuel rail (2) and lay to one side.

NOTE: Do not detach fuel line.

Release screws (1).

Tightening torque 11 61 1AZ .

Unscrew nuts (3).

Tightening torque 11 61 2AZ .

Fig 4: Identifying Fuel Rail, Screws And Nuts
G04751271Courtesy of BMW OF NORTH AMERICA, INC.

Graphic (E92).

Raise intake plenum approx. 10 cm.

Disconnect plug connections (1) at bottom.

Fig 5: Identifying Plug Connections
G04751272Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Replace all gaskets.

Assemble engine.

scientia non olet · About LEMON Manuals