17 11 035 Removing And Installing/Replacing Fan Cowl With Electric Fan (N55)

Necessary preliminary work:

Release screw (1) on fan cowl.

Tightening torque: 17 10 4AZ .

Detach charge air duct (2) from fan cowl.

Fig 1: Charge Air Duct And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and disconnect plug (1) on fan cowl on right.

Fig 2: Plug On Fan Cowl

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip fan cowl (1) at clamps (2) on left and right, feed out in upward direction and remove.

Fig 3: Unclipping Fan Cowl

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Insert retaining tab (1) at bottom on module carrier.

Fig 4: Retaining Tab

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check stored fault message.
Reassemble the vehicle.
Delete fault memory.