Removing and installing/replacing 12-V power socket (2016-2022)

Special tools required: 

• 61 0 250

Necessary preliminary tasks: 

• REMOVE FRONT STORAGE COMPARTMENT .
• REMOVE REAR CENTER CONSOLE COVER .
• REMOVE LUGGAGE COMPARTMENT WHEEL ARCH PANEL .

Check the equipment dependent sockets that are available.

Cup holder: 

Unclip connector (1) and feed through under center console to power socket (2).

Remove power socket (2) using special tool 61 0 250.

Courtesy of BMW OF NORTH AMERICA, INC.

Rear center console trim: 

Remove socket (1) from the center console trim using special tool 61 0 2502.

Courtesy of BMW OF NORTH AMERICA, INC.

Luggage compartment: 

Put your hand behind the right luggage compartment wheel arch panel.

Detach connector (1) from power socket (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Luggage compartment: 

Fold up the protective cap over power socket (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Luggage compartment: 

Remove socket (1) using special tool 61 0 250.

Courtesy of BMW OF NORTH AMERICA, INC.

Pull out 12-V power socket from housing with special tool 61 0 250 until connector is at bottom of light ring.

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out power socket (1) in direction of arrow with a suitable tool.

Courtesy of BMW OF NORTH AMERICA, INC.

Release latch mechanisms (1) with a suitable tool.

Press power socket mounting (2) in direction of arrow out of power socket frame (3).

Installation note: 

Latch mechanisms (1) at socket mounting (2) must not be damaged. Make sure socket mounting (2) is fitted correctly in socket frame (3).

Courtesy of BMW OF NORTH AMERICA, INC.