REP-TAT-P-5145-02 Installing the trim panel for the pedal mechanism

Check 

• Check the clamps (1) and guides (2) for damage.

  Courtesy of BMW OF NORTH AMERICA, INC.

Desired state 

• No cracks or fractures.

Result 

» The clamps (1) or guides (2) are damaged.

Measure

• Replace the clamps or the pedal mechanism trim panel.

  Parts: Clamps, trim panel for pedal mechanism

  • Connect connector.
  • Feed in trim panel for the pedal mechanism in the area of the bulkhead and in the area of the center console into the guides.
  • Install the trim panel for the pedal mechanism and press until the clips engage.
  • Tighten the screws (1).

    Tightening torques 

    Trim panel for the pedal mechanism on the support for the instrument panel
    	4.6Nm

    Courtesy of BMW OF NORTH AMERICA, INC.