41 61 010 Removing And Installing Engine Compartment Lid (Active Pedestrian Protection AFGS)
WARNING: This page is about a different car, the 2015 BMW ActiveHybrid 7, 2014 BMW ActiveHybrid 7, and 2013 BMW ActiveHybrid 7. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Danger of injury!
The BATTERY EARTH LEAD must be clamped off on vehicles with AFGS active pedestrian protection!
Adhere to the following SAFETY INFORMATION so as to avoid a danger of injury by the actuator.
The BATTERY EARTH LEAD must be clamped off on vehicles with AFGS active pedestrian protection!
Adhere to the following SAFETY INFORMATION so as to avoid a danger of injury by the actuator.
IMPORTANT:
Support engine compartment lid in fully opened position with suitable apparatus.
Removal of the engine compartment lid must be carried out with the assistance of a second person.
Removal of the engine compartment lid must be carried out with the assistance of a second person.
Follow instructions on ACTIVE PEDESTRIAN PROTECTION system.
Necessary preliminary tasks:
Disconnect NEGATIVE BATTERY CABLE .
Unscrew nuts (1).
Remove engine compartment lid.
Installation note:
Install engine compartment lid at screw locations to on hinge.
Tightening torque 41 61 1AZ .
If necessary, adjust ENGINE COMPARTMENT LID .