51 00... Notes on installation of rubber window seals

• Wear safety goggles, protective gloves and if necessary an apron.
• Do not eat, drink or smoke in the area of processing/application
• Ensure rooms are well ventilated.
• Keep away from heat and ignition sources
• In event of skin contact: Wash areas of skin affected with soap and water immediately, change work clothing which has been fouled with lubricant immediately (keep spare work clothing in reserve)
• In event of eye contact: Rinse eyes immediately with plenty of water and seek medical advice
• Observe the safety data sheet

• Use approved lubricant for installation only
• Application only at room and object temperatures between 18 and 25 °C
• Lubricant dries at different rates depending on the quantity, temperature and ventilation and becomes sticky
• Lubricant can only be used for fitting and not for fault elimination (e.g. grating)
• Newly painted parts may only be brought into contact with the lubricant after cooling
• Optimal bonding to the surface is achieved after approx. 48 h. The rubber window seal must not be exposed to mechanical strain beforehand. (car wash, strength test, etc.).

Attention! 

To avoid groaning noises, do not use soapy water (low-surface-tension water with washing-up liquid) or lubricant containing silicone.

• CLEANING AGENT R1 OR CLEANING AGENT R2 , cleaning cloth, plastic scraper, needle
• LUBRICANTG14* 

• Heat and remove anti-friction agent residues with a hot air blower or clean new part thoroughly
• Immediately prior to fitting, clean the work area in order to remove silicone and grease residues

• Apply a thin coating of lubricant to the rear side of the rubber window seal only
• Perform fitting within 30 min of applying lubricant
• Lubricant dries after fitting and becomes sticky