12 14 650 Replacing intake plenum (N55 Hybrid)
WARNING:
High-voltage system - danger to life!
The following points must be strictly observed prior to starting work:
The following points must be strictly observed prior to starting work:
- Observe SAFETY INFORMATION for handling hybrid cars.
Necessary preliminary tasks:
- Read out the fault memory of the DME control unit.
- Switch off ignition.
- Remove INTAKE SILENCER HOUSING .
Unlock connector (1) and remove.
Release screws and pull suction pressure sensor (2) out of intake plenum.
Tightening torque 13 62 4AZ .
Installation note:
Check sealing ring for damage. Replace damaged sealing ring.
When installing, coat sealing ring with suitable lubricant.
NOTE:
Reassemble the vehicle.
Check stored fault message.
Delete fault memory.