Installing air conditioning compressor
- Guide in the air conditioning compressor (3) .
- Replace the sealing ring of the refrigerant line (2)
.
Parts: Sealing ring
- Connect the refrigerant line (2) .
- Tighten down screw (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Refrigerant line on air conditioning compressor | ||
| M8 | tightening torque | 19 Nm |
- Replace the sealing ring of the refrigerant line (2)
.
Parts: Sealing ring
- Connect the refrigerant line (2) .
- Tighten down screw (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Refrigerant line on air conditioning compressor | ||
| M8 | tightening torque | 19 Nm |
- Install holder (2) .
- Tighten down screws (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Air conditioning compressor holder to crankcase | ||
| M8 | Tightening torque | 23 Nm |
- Mount the air conditioning compressor (2) on the holder.
- Tighten down screws (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Air conditioning compressor to holder/engine | ||
| M8 | tightening torque | 22 Nm |
- Connect and lock the connector (1) of the air conditioning compressor.
Follow-up work
- Refer to INSTALLING THE DRIVE BELT FOR ALTERNATOR 2 AND THE AIR CONDITIONING COMPRESSOR .
- Refer to CHECKING THE DRIVE BELT FOR ALTERNATOR 2 .
- Refer to REMOVING THE PROTECTIVE PLATE AT THE RADIATOR .
- Refer to INSTALLING FAN COWL .
- Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
- Refer to INSTALLING LEFT INTAKE PORT .
- Refer to INSTALLING RIGHT AIR DUCT .
- Refer to INSTALLING THE LEFT-HAND AIR DUCT .
- Refer to INSTALLING LEFT INTAKE SILENCER HOUSING .
- Refer to INSTALLING RIGHT INTAKE SILENCER HOUSING .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING FANFARE HORN, RIGHT .
- Refer to INSTALLING THE FANFARE ON THE LEFT SIDE .
- Refer to INSTALLING THE CENTER TOP CROSS CONNECTION .
- Refer to INSTALLING BOTH HEADLIGHTS .
- Refer to INSTALLING BUMPER COVER, FRONT .
- Refer to INSTALLING THE ACTIVE STABILIZER IN FRONT .
- Refer to SECURING THE ANTI-ROLL BAR LINK ON THE LEFT AND RIGHT TO THE ANTI-ROLL BAR .
- Refer to INSTALLING THE COVER OF THE STEERING ASSEMBLY ON THE RIGHT .
- Refer to INSTALLING FRONT STIFFENING PLATE .
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD .
- Refer to INSTALLING FRONT SECTION OF THE FRONT WHEEL ARCH COVER (PARTIALLY REMOVED) .
- Refer to INSTALLING THE FRONT RIGHT WHEEL .
- Refer to INSTALLING FRONT ORNAMENTAL GRILLE .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT CENTER .
- Refer to ADJUSTING HEADLIGHTS .
- Refer to EVACUATING AND CHARGING CONDITIONING .